![]() (*) The parameter name can be any string: param1, parameter, aaa, etc. ![]() ![]() As Adapter module tab in PI trims strings by the right side, if it’s needed to replace OldString by a blank string or an empty string, the values blankString or emptyString have to be used. This parameter is used to obtain Old string to be replaced by the New string in the message. This parameter configures the character that separates a pair of strings. The table below shows the possible parameters and values of the adapter module. Insert the module in front of the adapter module as shown in the picture below. ![]() This section describes all the activities that have to be carried out in order to configure the module. The module can be used in any Sender or Receiver File/FTP Adapter. The module accepts multiple string pairs to allow multiple replacements in one execution.Įnterprise Java Bean Project: RenameFile_EJBĮnterprise Java Bean Application: RenameFile_EAR Finally it updates the key with the new value and the original message is returned. Then it searches within the filename and replace each occurrence with. Reads the Dynamic Configuration key of the message. The module obtains a pair of string : as parameter. It can be used to modify a part of the file name of the message before it gets in PI and also before it gets out. RenameFile module is used to replace strings within the value of Dynamic Configuration key.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |